OX281 - Oxford Rear Premium Motorcycle Paddock Stand

Product Information

The difficulty with using any cantilever type stand is that the bike wants to tip over when it is unsupported. I think that some of the reviewers have been putting their bikes up on the stand for the very first time, without the aid of a helper. This in my experience is not always a recipe for success. You can blame the stand that your bike fell over but it is not always the fault of the stand. Perhaps the manufacturer or retailer could make this point to first time users and save everyone a lot of heartache. They can also be very useful for general maintenance; if your bike doesn’t have a centre stand but does use a chain, then cleaning and lubricating the chain is far easier if the rear wheel is off the ground, as is adjusting the chain tension. The best at a glance Lots of Triumph owners opt for the single-handed bike lift options like a 1Jac on Con Stand, which lifts the whole bike off the floor.

We see no reason why this wouldn't fit your motorcycle as the plates can be adjusted to the desiredwidth.

Front paddock stands

Unfortunately as this is a universal product we are not able to advise on specific fitments, apologies. Oxford list the the stand as suitable for swing arms with overall widths of260-355mm. The cups/pads should lift your bike ok, but should you wish to fit bobbins, the necessary hooks are included with thestand.

Front stands work in a number of ways. Either they have pins which locate under the fork legs or they have rotating cups which can locate either under the forks or, if you have radial brakes, you can fit them under the radial assembly on the fork leg itself. The Triumph Tiger 800 XC usually takes M8 size bobbins, but we are unable to advice on the pitch of the thread,apologies. Hi there, is this stand suitable for a 2018 Kawasaki Z1000SX with Kawasaki bobbins? KindRegards. March 26, 2019 Thankfully, this sturdy dolly stand from Oxford has a few neat features to alleviate that issue. Firstly, the arms that cradle the fork legs have rubber pads to prevent scratching, providing an opportunity to get them settled first without risking damage to paintwork. They're spring-loaded, too, locating the pads positively under the fork ends so they don't slip out. Easy-to-use stands that make lifting a bike effortless with touches to ensure once in the air, your pride and joy is held there safely." - RiDE Magazine Best BuyThis is suitable for your Tiger 800, but we would always recommend using a stand with hooks and bobbins ifpossible.